Printable Parts - V1.1 - Imperial

Printable Parts - v1.1 - Imperial

File Size: 1.9Mb
NOTE: This is an older version of the tracking station and ThumbSat recommends you use version 2.2 instead, as it is designed for better wind loads and stability.

The zip file here contains all of the 3D printable parts required to make the basic ThumbNet tracking station version 1.1.

The files are designed for imperial measurements using 3/4 inch support rods for Elevation and Azimuth.

Feedback on any aspect of the design is welcome.

Back to ThumbNet Tracking Station